Rewiring
Rewiring Older Homes in Hallsville & East Texas
Two-prong outlets, cloth-covered wiring, aluminum branch wiring, or knob and tube? Rieger Electric rewires older East Texas homes with minimal wall damage. Call (903) 736-6952.
Rewiring Older Homes
A lot of older East Texas homes still run on wiring that was put in decades ago. Two-prong outlets with no ground. Cloth-covered wiring that is drying out. Aluminum branch wiring from the 1960s and 70s. Knob and tube from even earlier.
These get flagged on home sale inspections and by insurers. They can also cause real problems, from flickering lights to outlets that stop working to breakers that trip for no clear reason.
We rewire older homes, either in part or as a whole home, and we keep wall damage to a minimum. We plan the route with you so you know what gets opened and what stays closed.
Signs you need this
- Two-prong outlets with no ground
- Cloth-covered wiring that is fraying or brittle
- Aluminum branch wiring from the 1960s and 70s
- Knob and tube wiring in an older home
- Wiring flagged on a home sale inspection or by your insurer
- Outlets or switches that work intermittently or not at all
How Rieger Electric does the job
- 1
We look at what you have
We identify the wiring type and condition, and where it runs. We tell you what is safe and what should be replaced.
- 2
We plan partial or whole home
A partial rewire fixes the worst of it. A whole home rewire replaces everything. We help you choose based on the house and your budget.
- 3
We plan the wall access
We map out where we need to open walls and ceilings, and where we can fish wire without cutting. You know the plan before we start.
- 4
We rewire to code and patch
We run new grounded wiring to Texas code, pull permits where the city requires them, and leave access points ready for your patching or ours.
What affects the price
We explain the work and the price before we start. These are the things that change the scope, not a quote. Call us for your number.
- Whether it is a partial rewire or a whole home rewire
- The wiring type being replaced, like knob and tube or aluminum branch
- How much wall and ceiling access is needed to reach the runs
- Whether the panel needs updating to support the new circuits
- Whether a permit and inspection are required by your city
Safety and code notes
- Aluminum branch wiring from the 1960s and 70s can loosen at connections and heat up. It is a known fire concern and often flagged by insurers.
- Knob and tube was not built for modern loads. It has no ground and the insulation can be brittle after decades.
- Cloth-covered wiring dries out and cracks over time, which can expose conductors inside walls.
Towns we serve
We serve East Texas within about 50 miles of Hallsville, TX.
Harrison County
Gregg County
Upshur County
Marion County
Panola County
Rusk County
Smith County
Rewiring Older Homes questions
Do I have to rewire the whole house at once?
No. We can do a partial rewire to fix the worst of it, like a single circuit or one room, and plan the rest for later. We help you decide based on the house and your budget.
Why did my insurer flag my wiring?
Insurers often flag knob and tube, cloth-covered wiring, and aluminum branch wiring because of known fire risks. Rewiring removes that flag and can make the home easier to insure.
Will you have to cut open all my walls?
Not all of them. We plan the route to fish wire where we can and only open walls where we have to. We map the access points with you before we start.
How do I know what kind of wiring I have?
We can look at a few outlets and your panel and tell you. Two-prong outlets, cloth insulation, and single aluminum conductors are common signs of older wiring.
Do you pull permits for rewiring?
We pull permits where the city requires them and do the work to Texas code.
Call us, it's fastest
(903) 736-6952Tell us what's going on.
Calling is fastest. Prefer to type? We'll get back to you during business hours.